Broken Arms Q&A Forum

You are not logged in. Would you like to login or register?



  • Index
  •  » General Discussion
  •  » Fitting quill stop on small drill.

    • 1 of 1

       

    4/24/2015 2:17 pm  #1

    Mike
    Moderator

    Offline

    Registered: 11/01/2013
    Posts: 122

    Fitting quill stop on small drill.

    Clever idea if your drill press doesnt have a quill stop.



     

     

    1/10/2016 9:34 am  #2

    tmc_31
    New member

    Offline

    Registered: 1/10/2016
    Posts: 6

    Re: Fitting quill stop on small drill.

    Hey Mike, cool idea. Consider installing a small brass plug between the screw and the quill face to keep from marring the side if the quill.

     

    1/12/2016 1:33 pm  #3

    Mike
    Moderator

    Offline

    Registered: 11/01/2013
    Posts: 122

    Re: Fitting quill stop on small drill.

    Here are some helpful links.

    Brass tipped screw
    http://www.mcmaster.com/#brass-tipped-screws/=10njm1a

    Handles
    http://www.mcmaster.com/#control-handles/=10njoh1

    Thumb screws
    http://www.mcmaster.com/#standard-thumb-screw-knobs/=10njocl

    Knobs with threaded stud
    http://www.mcmaster.com/#machine-component-knobs/=10njobx

    Brass round stock
    http://www.mcmaster.com/#standard-brass-alloys/=10njxq9

       •Thread Starter
     

     

    1 of 1

  • Index
  •  » General Discussion
  •  »  Fitting quill stop on small drill.

    • Board footera

     

    Powered by Boardhost. Create a Free Forum