Broken Arms Q&A Forum

You are not logged in. Would you like to login or register?



  • Index
  •  » General Discussion
  •  » Drilled into mag release

    • 1 of 1

       

    3/29/2016 2:21 pm  #1

    Gto
    New member

    Offline

    Registered: 3/29/2016
    Posts: 2

    Drilled into mag release

    I have drilled out 2 .223 lowers and one .308 using the broken armory jig the first one .223 came out fine. The  other .308 and .223 came out with a hole into the mag release in the same spot. I don't know what caused this and I have several more to do. The drill bits are all straight has anyone had this issue?

     

    3/29/2016 3:02 pm  #2

    scorpiusb
    Member

    Offline

    From: Alabama
    Registered: 2/28/2016
    Posts: 18

    Re: Drilled into mag release

    Can you post some pictures?

    Bart
     

    4/09/2016 4:00 pm  #3

    Mike
    Moderator

    Offline

    Registered: 11/01/2013
    Posts: 122

    Re: Drilled into mag release

    Ive never run into this issue.  Give me a call when you have a moment so we can figure it out.  408-753-1112

     

    4/22/2016 8:08 pm  #4

    Gto
    New member

    Offline

    Registered: 3/29/2016
    Posts: 2

    Re: Drilled into mag release

    This issue was due to the drill press table not being level....

       •Thread Starter
     

     

    1 of 1

  • Index
  •  » General Discussion
  •  »  Drilled into mag release

    • Board footera

     

    Powered by Boardhost. Create a Free Forum